Installing the hardware

SMB Kit components

Installing the Gallagher SMB Kit hardware involves the following steps:

1. Install the cabinet

2. Install readers

3. Connect inputs and outputs

4. Connect power to the controller

5. Connect the controller to the cloud

6. Initialise tampers

For the full procedures for the above steps, refer to the appropriate SMB Kit installation note, depending on your region:

• SMB Base Kit - NZ/AUS

• SMB Base Kit - North America

As an additional aid, you may also refer to the appropriate hardware installation video module, which contains mostly the same information as the SMB Base Kit installation note:

Australia & New Zealand

Hardware Installation - FULL

Connect HBUS Devices

Connect Inputs & Outputs

Permaconn

USA

Hardware Installation - FULL

Connect HBUS Devices

Connect Inputs & Outputs

Alula

Other hardware components

Refer to the relevant installation notes for any additional hardware components you need to install:

• Gallagher SMB Demonstration Case - NZ/AUS (C500900)

• Gallagher SMB Demonstration Case - USA (C500901)

• Permaconn PM54 (NZ/AUS only)

• SMB Monitoring Kit (North America only)

• Gallagher SMB HBUS I/O 8In Board (NZ/AUS only)

• Gallagher SMB HBUS I/O 8In 4Out Board

• Gallagher SMB T11 Reader

• Gallagher SMB T15 Reader

• Gallagher SMB T30 Reader

The following hardware components are compatible with the SMB solution:

• Gallagher HBUS 16 In 16 Out Board (C300688)

• Gallagher HBUS 8 Port Hub (C300698)

The following low level integrations are also available with the SMB solution:

• Gallagher SMB & Inovonics

• Gallagher SMB Low Level Perimeter Integration

Connecting HBUS Devices

Second Tab