The Controller’s cloud configuration web pages allow configuration of specific Controller settings, including the Controller’s date/time and NTP server if needed.
To connect to the Controller’s cloud configuration web pages, there are two methods:
| Method | Procedure |
|---|---|
Navigate to the Controller's IP address
Find the IP address that has been assigned to the Controller by the local DHCP server.
Set DIP switch 1 to ON.
Connect a laptop/PC to the same network as the Controller.
Using a web browser, go to the Controller’s cloud configuration web page, replacing <ip_address> with the assigned IP address for the Controller:
http://<ip_address>/cloud/
The Sign In dialog displays.
Enter cloud for the username, then GGLcloud for the password and press Enter.
The Gallagher Cloud Controller Configuration web page displays.
Select the required link to configure the Controller as needed.
When finished, set DIP switch 1 to OFF.
Reset the Controller's IP address, then navigate to it
If you cannot find the Controller's DHCP IP address, the Controller can use the default IP address by powering it on with DIP switches 1, 2, and 3 ON. The Controller then uses the following default addresses:
Controller IP: 192.168.1.199
Gateway: 192.168.1.198
Subnet: 255.255.255.0
Connect the Controller to your PC via the Controller's Ethernet port.
Set DIP switches 1, 2 and 3 to ON.
Power cycle the Controller.
Using a web browser from a PC on the same subnet as the Controller, enter the default IP address of the Controller as follows:
http://192.168.1.199/cloud/
The Sign In dialog displays.
Enter cloud for the username, then GGLcloud for the password and press Enter.
The Gallagher Cloud Controller Configuration web page displays.
Select the required link to configure the Controller as needed.
When finished, set DIP switches 1, 2 and 3 to OFF.