For the complete documentation index, see llms.txt. This page is also available as Markdown.

Set up card, PIN and biometric combinations

Set up card plus biometric plus PIN, card only, and finger only access on IDEMIA readers.

These are the usual card and reader combinations for IDEMIA (Morpho) readers. The user guide describes every configuration. To add a Morpho object to cards, see Encode cards for IDEMIA readers.

Card, biometric and PIN

The card must have the card number and biometrics encoded on it.

  1. On the card type, tick Use PINs.

    MIFARE DESFire Properties, PINs: Use PINs ticked, minimum PIN length 4
  2. On the card type used for the cardholder, set the Morpho object to Card Number + Biometrics, with Reader ignores PIN unticked. If cards are already encoded and you change this, they must be re-encoded.

    DESFire Properties - Morpho: Contents Card Number + Biometrics, Reader ignores PIN unticked
  3. The reader does not need Always request PIN ticked. But if the cards were encoded with Reader ignores PIN ticked on the card type, ticking Always request PIN makes the Morpho reader ask for a PIN from a cardholder presenting a card.

    Morpho Sigma Multi Reader Properties, Advanced Setup: Always request PIN, which overrides the Reader ignores PIN setting of the card layout; the reader always requests a PIN, and the setting only applies to biometric readers with PIN entry keypads

Card only

Use this when a biometric is not required.

  1. In the Card Layout editor of the card type, make sure the Morpho object has only Card Number Only selected. A card encoded with a biometric before must be re-encoded with the new setting.

    MIFARE DESFire Morpho no Biometrics - Card Editor: DESFire Properties - Morpho, Contents Card Number Only, Reader ignores PIN unticked
  2. On the reader, the mode must be Card Selects.

    Morpho Sigma Lite Reader Properties, Setup: Authentication Mode Card Selects, Connection Mode MA5G (the IP address is covered)

With Card Selects, a cardholder without a Morpho object on their card cannot get through. On a site where some cardholders still use their finger, Encode cards for IDEMIA readers explains when to use User Selects instead.

The newer reader screen does the same: on the reader's Setup tab, tick only Card under Authentication Method, and encode the cards with a Morpho DESFire object set to Card Number Only. The reader then works as card only and does not need a biometric.

Morpho Sigma Multi Reader Properties, Setup: Authentication Method with only Card ticked (the IP address is covered)
Card Editor: Morpho DESFire object, DESFire Properties - Morpho with Contents Card Number Only and Reader ignores PIN unticked

Finger only

  1. The fingerprint templates must be stored in the database, so they can be sent to the readers and stored there to allow access (Morpho Biometric Type, Advanced tab, Save biometrics to database).

    Morpho Biometric Type 1 Properties, Advanced: Privacy Settings, Save biometrics to database ticked
  2. Set the readers to Finger Only. (The same can be had with the reader in User Selects mode.)

    Morpho Sigma Lite Reader Properties, Setup: Authentication Mode Finger Only (the IP address is covered)

Last updated

Was this helpful?