For the complete documentation index, see llms.txt. Markdown versions of documentation pages are available by appending .md to page URLs.
Skip to content

Configure Otis Compass networking

Configure NIC addressing and routes for an Otis Compass HLI connection.

The Otis Compass HLI service requires a dedicated network interface.

Configure the standard network

Install FT Otis Compass HLI Service on a server with a NIC configured as follows:

IP address:  192.168.50.250
Subnet mask: 255.255.255.0

Connect NIC 2 directly to the Otis Layer 3 switch. Do not use intermediary switches.

Intermediary switches can block multicast traffic. Elevator controllers may then remain offline.

Configure an alternate subnet

Use two NICs when Command Centre and Otis use different subnets. Connect the Command Centre server directly to the Otis Layer 3 switch.

Alternate subnet diagram - CC server with two NICs, directly connected to the Otis Layer 3 switch for the Compass HLI network
  1. On the controller Advanced Networking tab, enter the local server IP address.

Controller properties - Advanced Networking tab with the local server IP entered for the Controller NIC
  1. On the Elevator HLI Advanced tab, enter that address in Additional configuration.

Elevator HLI properties - Advanced tab with the local server IP entered in the Additional configuration field
  1. Stop FT Otis Compass HLI Service, then configure routing.

    This assigns the preferred interface by using the lowest metric.

    This removes the existing multicast route.

    This assigns the lower metric to multicast traffic.

    Replace X with the 192.168.50.250 NIC interface number. Use ipconfig /all to identify its MAC address. Match that address in route print.

Routing table example - showing the 224.0.0.0 multicast route correctly assigned to the 192.168.50.250 interface with metric 55
  1. Restart FT Otis Compass HLI Service.

Configure the service file

The sample file is located at:

Copy OtisCompassHli.conf.sample and rename the copy OtisCompassHli.conf.

Last updated

Was this helpful?