Duress terminal (formerly Duress RAT)
The Duress Terminal feature turns a T20 HBUS Terminal or Remote Arming Terminal (RAT) into a permanent Duress Alarm Panel that stays in alarms view without any login or navigation, so guards can watch for and respond to alarms continuously. A common use is monitoring duress alarms triggered by people in physical danger.
What it is
The Duress Terminal feature introduces the Duress Alarm Panel, which contains:
a Duress Terminal (T20 or RAT)
an LED, illuminated if the Duress Terminal contains active or unacknowledged alarms
a siren, which sounds if a new alarm occurs at the Duress Terminal
a pushbutton which silences the siren (until another alarm occurs)
The feature allows a T20 HBUS Terminal or RAT to permanently remain in alarms view (without login or navigation) to display alarms to guards so they can respond. The Menu option on a T20 Duress Terminal does not display, and is optionally replaced with an Acknowledge (acknowledge alarm) option.
One use for this feature is for guards to monitor duress alarms, which are triggered by people who are in physical danger.
Command Centre versions supported
Per the source page (a tick = supported):
✓
✓
✓
✓
✓
✓
✓
✓
Supported in v7.90 through v8.40, and again in v8.90 and v9.00. The source shows no support across v8.50 to v8.80.
Release notes
Release notes for each supported version (newest first):
🔗 Related
Command Centre - Alarm Zones. The alarms a Duress Terminal displays and acknowledges.
Last updated
Was this helpful?
